|
|
|
|
|
Heat Treatment
Equipment |
| |
 |
|
◄415v
3 phase step down transformers.
Used to provide the
60 v power supply for the ceramic heating pads.
Also provides the 110v power supply for the Auto
Programmer and the Temperature Recorder
|
|
|
|
|
|
P250A Auto
Programmer.►
Used to control the
heating rate, hold time and cooling rate to the
required specification.
|
|
 |
|
|
|
|
|
 |
◄
Sekonic 12 point Temperature Recorder.
Used to provide a
permanent record of the temperature heating rate, hold
time and cooling rate of the work carried out.
|
|
|
|
Thermocouple
Attachment Unit - T.A.U.
►
Used to attach the
thermocouple to the workpiece, via a capacitance
discharge.
|
|
 |
|
|
|
|
|
 |
◄
6Way Mains Voltage Controller
Is mainly used as a 6
way distribution board for the 415v main supply
|
|
|
|
A standard set of
heat treatment equipment, consists of:- 1x
Transformer, 1x P250A, 1x Sekonic Recorder, 1x
T.A.U, 6x Triple Cables,
12x Splitter, 18x Heating Pads, Thermocouple
Wire, Mild Steel
Tie Wire and Insulation
|
 |
|
|
|
|
 |
◄
Flexible Ceramic Pad
Heaters.
The heating pads are
manufactured in various sizes, to allow for the
heating of various
weld sizes / configurations
|
|
|
An example of a pipe
butt weld wrapped with ceramic pad heaters on either
side of the weld.
►
|
 |
|
|
 |
These heaters are
designed to be used in a temporary furnace.
|
|
|
A triple cable
consists of 2 cables for the power to the heating
pads, and a third cable to measure the temperature
of the workpiece.
|
 |
|
|
 |
◄
Splitters
A 3 way splitter,
enables you to use 3 heating pads per control zone.
|
|
|
Type K Thermocouple
Wire
►
This is attached to
the work piece, using a T.A.U., to measure the
temperature.
|
 |
|
|
 |
Is used as the third
cable in a triple cable set, to carry the signal
from the thermocouple to the
temperature recorder.
|
|
|
| |
|
|
